Transaxle autopsy 1-8 | 9-16 | 17-24 | 25-32 | 33-40 | 41-48 | 49-56 | 57-60
|
|
The snap ring and shim hold the sleeve in place with no play. |
|
|
Before it all goes back together, there's one more piece to add: this little roller bearing. It's easy to forget, so I labeled it with a big piece of tape when I removed it. |
|
|
It's small, and it's easy to lose. |
|
|
It goes on the end of the input shaft that fits into the freewheel hub. |
|
|
Here's the bearing in place on the tip of the shaft. |
|
|
This is the freewheel hub. The input shaft fits into the splined hole in the center. |
|
|
With all the pieces installed, it's time to put together the front and rear halves of the case. I've put Hylomar HPF sealant on the flanges. |
|
|
Now all we have to do is bolt together the two halves of the case. |